Stereo Power Amp...500W/8, 750w/4 and 1200W/2 Ohms per Side
ShopMSL price: $849.99
ShopMSL saves you $150.00 (15%)!
The RMX Series amplifiers give you clean, dynamic power with the legendary QSC sound quality and reliability that pros depend on. The RMX Series deliver unmatched performance at a breakthrough price.
The power supply is the heart of an amplifier, converting raw AC power from the wall to clean DC for the audio circuitry. The RMX uses a powerful high-current toroidal transformer and ample filter capacitance to ensure generous energy reserves. This makes a critical difference in sound quality, allowing the amp to effortlessly punch out high-level transients, even when driving abusive 2-ohm speaker loads
The RMX Series is packed full of professional features that increase performance and flexibility:Independent defeatable clip limiters reduce distortion without sacrificing peak performance.Selectable low-frequency filters boost system response, protect speakers and ensure low-end tightness by more precisely matching the amplifier’s range to the loudspeakers.Barrier strip, XLR, and 1/4 in. balanced inputs plus Speakon and binding post outputs provide easy connections.Low-noise variable speed fans with rear-to-front air flow keep amplifiers and racks cool.
8 Ohms: 500 W4 Ohms: 750 W2 Ohms: 1200 W8 Ohms Bridged Mono: 1500 W4 Ohms Bridged Mono: 2400 WCurrent Consumption: 10 AmpsDistortion (Typical):
20 Hz-20 kHz: 10 dB below rated power Less than 0.03% THD 4 and 8 ohms
1.0 kHz and below: full rated power Less than 0.03% THD 4 and 8 ohmsFrequency Response: 20 Hz-20 kHz, +/- 1 dB, -3 dB points: 5 Hz-50 kHzDamping Factor, 1 kHz and below: Greater than 300 at 8 ohmsInput Impedance: 10 k ohms unbalanced, 20 k ohms balanced
Input Clipping: 10 Vrms (+22 dB)
Cooling: Continuously variable-speed fan, rear-to-front air flow
Connectors, each channel
Input: Active balanced; barrier strip, XLR and 1/4 in. (6.3mm) TRS tip and XLR pin 2 positive
Output: touch-proof binding posts and Neutrik Speakon
Front: AC switch, Ch. 1 and Ch. 2 gain knobs
Rear: 10-position DIP switch
Power On: Green LED
Signal: Yellow LED, 1 per channel
Clip: Red LED, 1 per channel
Full short circuit, open circuit, thermal, ultrasonic, and RF protection
Stable into reactive or mismatched loads
Load Protection: On/off muting, triac crowbar (on each channel)